Pattern board source - CNCzone.com-The Largest Machinist Community on the net!

zcases · #1 01-28-2006, 08:50 AM

Can someone recommend a good source for pattern board in small quantities? I need it ~3" thick, ~6" squares, and need to get a good surface finish with a 1/16 ball end mill on a CNC.

All my searches yield manufacturers of the stuff, but I cannot seem to find retailers, even on eBay.

Thanks
Scott

dpryor · #2 02-02-2006, 11:22 AM

Are you looking for something like REN urethane tooling board?
If so, where are you located?

zcases · #3 02-03-2006, 06:21 AM

Yeah - REN is just what I'm looking for, or an equivalent. I am in Binghamton NY.

dpryor · #4 02-03-2006, 09:34 AM

We get ours usually from Freeman Supply www.freemansupply.com . They have loctaions around the country including Cleveland Ohio & Harrisburg PA.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)