Newbie- which mold design

[baxr6]

Hi all,

just wondering if anyone can point me in the right direction of how to build the mold for the part below.all the parts in the image are identical.would I have to do it in to pieces (cut vertically).any help would be aprreciated.

I was going to use silicon rubber as the mold and something like solid cast 650 from here

the parts are about 1" or 25mm tall and about 1 7/8" or 48mm O.D.


Thanks

[Mike 1948]

Originally Posted by baxr6 Hi all, just wondering if anyone can point me in the right direction of how to build the mold for the part below.all the parts in the image are identical.would I have to do it in to pieces (cut vertically).any help would be aprreciated. I was going to use silicon rubber as the mold and something like solid cast 650 from here the parts are about 1" or 25mm tall and about 1 7/8" or 48mm O.D. Thanks

I would say you are looking at 2 pieces along the centerline that would have to be bonded together somehow.

Mike

[baxr6]

thanks greatly appreciated