Mods - CNCzone.com-The Largest Machinist Community on the net!

gdl357 · #1 09-08-2004, 10:30 PM

Just added a DRO Unit and a quick change post to my lathe. Now all I need is a 4" 4 Jaw chuck and I'm rockin'

DRO Unit.

http://www.mini-lathe.com/Mini_lathe...g_DRO/dro2.htm

Good stuff.

CNCadmin · #2 09-08-2004, 11:00 PM

It's a nice add on I have that on my lathe as well and it works very well.

gdl357 · #3 09-08-2004, 11:51 PM

Do you think a 5" 4 jaw chuck is pushing it a little, or should I stick with the 4".

thx

CNCadmin · #4 09-09-2004, 12:20 AM

I'm using a 4", I think 5" is pushing it a little.

balsaman · #5 09-09-2004, 09:29 PM

I got a 3" and just chuck it in my 4", 3 jaw when I need it.

Eric

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
shoptask 3/1 lathe/mill assembly and mods	Bloy2004	Shopmaster/Shoptask	131	01-24-2008 09:06 PM
MTC 4'X8' rework	duluthboat	DIY-CNC Router Table Machines	12	01-18-2006 03:02 PM
My New Custom System I am building.	WallCrawler	Computers and Networking	40	12-08-2004 08:31 PM
Any good mods	CNCadmin	Bridgeport and Hardinge Mills	1	02-01-2004 02:46 AM
Looking for a few good mods.	ToyMaker	CNCzone Club House	1	05-30-2003 06:40 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)