Results 1 to 2 of 2

Thread: Installed tach on 8x14

  1. 02-17-2008, 10:55 PM #1
    arekugi
    arekugi is offline
    Registered
    Join Date
    Jan 2008
    Location
    USA
    Posts
    3
    Downloads
    0
    Uploads
    0

    Installed tach on 8x14

    Completed my install of a tach (tachulator from LMS) on my LM 8x14 - in anticipation of upgrading to a VFD.

    Will attempt to place a pic.
    Attached Thumbnails Attached Thumbnails Installed tach on 8x14-taculator_sm.jpg  

  3. 02-18-2008, 01:19 AM #2
    tauntdesigns
    tauntdesigns is offline
    Registered tauntdesigns's Avatar
    Join Date
    Nov 2005
    Location
    USA
    Posts
    519
    Downloads
    0
    Uploads
    0
    Nicely done,

    A very sanitary modification.

    Jack
    Walking is highly over-rated

« Need Advice on Denford Mirac P.C | cnc lathe turret plans »

Similar Threads

  1. Macro B installed?
    By grweldon in forum Fanuc
    Replies: 8
    Last Post: 07-09-2007, 02:19 PM
  2. Manual plasma installed on a cnc problem!
    By baranac in forum CNCzone Club House
    Replies: 3
    Last Post: 08-10-2006, 02:08 AM
  3. EZTrak with factory installed 3rd axis.
    By Gncc50 in forum Bridgeport and Hardinge Mills
    Replies: 2
    Last Post: 04-08-2006, 02:13 PM
  4. Help gettig pure dos installed
    By Hack in forum TurboCNC
    Replies: 11
    Last Post: 10-02-2005, 10:26 PM
  5. Caps Installed Wrong Please HELP
    By jockey in forum General Electronics Discussion
    Replies: 6
    Last Post: 02-27-2005, 11:48 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.