Struggling with Emco CNC Lathe with WELSOFT upgrade

[scot101]

Hi

Can anyone help me please?
I purchased an EMCO CNC5 (converted to run WELSOFT) earlier this year on EBay. Not had much time to play with it so far, but have had a bit of a disaster - the PC containing the WELSOFT software harddisk has crashed. I'm in communication with WELSOFT trying to obtain a new copy of the code, however I wanted to see if there were other alternatives to make this work.

I have MASTERCAM 9 installed on the new PC, but don't seem to be able to get it to post the NC code to the lathe.

Any one got this working or able to offer any advise that can help me. Right now I basically have a dead machine!

regards Roddy McAskill

[odd vigtil]

Hei

Is it posible to oppgrade software on Emco DC 70 1994 mod