Can't load program from floppy

[dresda]

OK, now I think this is how it works.
If I use notepad or wordpad and "save as" and as you guys said no ext, It does work, but I was just saving it as lets say o1234 then it saves it as a text doc,
but if I save it it as o1234 and put a . then it saves as a file, does that make sense...
You guys were right, I just didn't know about the .
Ray.

[franchcnc]

" I save it it as o1234 and put a . then it saves as a file, does that make sense..."

I had never done it that way, but it seems work.

[dresda]

Ok, got the program to run now but have other problems.
I verified the program with Bobcad and it worked fine but when I ran it through my machine I get Error 509 Arc lack intersection, don't have alarm list for the Centurion 1, can you help.
Help.

[dresda]

This is strange, "The alarm 509 Arc lacks intersection" looks like a small gap in the run on the graph.
When looking at the dot moving along you can see several blocks ahead and there is a small gap and that's were it stops.
I have checked, run, verified and watched it machine the part in solid with my Bobcad, yet it stops on the Milltronics. It did two pockets and a hole with no problems.
Ray.

[ihbuilder]

I do not mean to hijack this tread but I got to say thanks to the OP and all the contributers just by reading a little I found this thread and solved 1 of 2 probs I'm having

Steve