Need Help!- Corrupt Software

[ericwaa]

I have a partner 4 and I have with a corrupt does anyone have or know where to get restore disks

Thanks

[mholden]

what version of control?

[ericwaa]

I think it is centurion 5

[mholden]

Then the software should be on ERPOMS.
you may try and reformat the software

[ericwaa]

I followed the instructions and replaced the battery.

Now Ive gotten the mach to boot partialy locks up at initializing acro loops

I found the machine SN is 1165 and the controller is a Cent5 SN 821B

Any help you provide is much appreciated.

[franchcnc]

Sounds like a acroloop card is not seated properly. Remove the cover from the control and check the green leds on the top of the acroloop boards(the 3 tall boards to the right of the one you replaced the battery on). If one is not on, turn off the machine and try to reseat it.

Cheers!

[von007]

Does your screen come up with the screen of death?
When the alarm pops is it on a dos screen?
plz include detailed info as corrupt doesn't quite cut it.
have u recently had electrical work done.....moved the machine etc.

von007
Chips AHOY