mastercam x3 and centurion 7 ?

[motor-vater]

Any help or suggestions with the post processors on this, I am pulling out the last of my hair on this...... Is there a post made for this can someone tell me where to go to buy this??? Thanks in advance

[motor-vater]

you guys suck!!!!!

[Superman]

you guys suck!!!!!

With this attitude, do you think you will get the assistance you need. even after you correct your error ...twice

motor-vater

Do you not think you may be posting to the wrong audience.

not every milltronics owner runs Mastercam
You are asking for help on a file required whilst running Mastercam, not the machine

You don't ask a gas station attendant , how to fine tune a high performance racing car.... he just pumps the gas

Also try emastercam for assistance, ( they do not supply posts, but would willingly help you modify the closest one to suit your machine )
In that forum, please supply ( attach ) a sample of code, and any other pertinant info, so that others may see how your machine runs, and possibly suggest a possible starting point.

Apologies will be accepted...... if offered

[panaceabea]

I figured with the nut kick avatar that he is just kidding .

I run x2 to generate tool paths for my cent7 controller and I dont believe you need any post processor. I just choose the 3axis vertical in the pull down for machine type and it outputs files that can be directly loaded into the milltronics

[frog]

Play Nice, Steppers are pretty simple as bipolar and unipolar go there are some wonderful models on the internet in color showing their functions, as for the wishing bad things upon us not very nice, I have learned more by browsing this site than any place on the internet, these people have been so helpful to me, look at my pictures in my gallery, that proves it, my advice is please don't bridges as for a source of information on the internet this is the best, if we have not had time to respond sorry first time I have seen this post, I as many others are very busy. Play nice!!!!