FILE NAMES - CNCzone.com-The Largest Machinist Community on the net!

LYN BYRD · #1 05-05-2009, 08:16 AM

ANYONE KNOW IF THE MILLTRONICS CONTROL (CENT. 7) WILL READ FILE EXTENSIONS? I HAVE TO ONLY USE THE (.) WITH NO EXTENSION.
THANKS

jpawelk · #2 05-06-2009, 11:07 AM

With the parameter FULL DOS FILE NAMES set to YES, the control will read any file along with any file extension. This parameter can be found under F7(PARMS), F1(SETUP), F1(LEVEL), then F5(MISC). If the parameter is set to no, place the cursor on the parameter and press F3(TOGGLE) and it will change to yes.

LYN BYRD · #3 05-06-2009, 11:26 AM

THANKS
I WILL TRY THAT

LYN BYRD · #4 05-11-2009, 08:52 AM

THE ONLY ISSUE THAT I HAVE IS I CANNOT CALL A PROGRAM NUMBER TO VERIFY, BUT I CAN CALL A PROGRAM NUMBER TO EDIT.??

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Changing file names	CNCMike	Solidworks	4	08-13-2008 09:44 AM
vf2 setting for 8x program names?	PaintItBlue	Haas Mills	3	06-27-2008 01:45 AM
Names	ErnieD	Trade Shows and Events	0	03-20-2007 05:48 PM
Plus sign next to names?	DAB_Design	Forum Questions or Problems	0	06-08-2005 11:26 AM
NAMES Expo	johnbutler	Trade Shows and Events	0	04-13-2004 09:57 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)