running off rotary phase converter - CNCzone.com-The Largest Machinist Community on the net!

Joe Miranda · #1 04-14-2008, 07:08 AM

Do I need to isolate the wild leg that comes from my rotary phase converter -and if so - which terminal do I use?

Joe

LYN BYRD · #2 04-14-2008, 07:19 AM

What machine do you have?

Joe Miranda · #3 04-14-2008, 08:59 AM

Lyn,

It's a lathe with a centurion V control. I think its vintage is '94 or '95.

Joe

LYN BYRD · #4 04-14-2008, 09:19 AM

My Milltronics machines all have the pc control (centurion 5 and up).
The wild leg is always L2. The other two go through a transformer before going to the pc. Hope this helps.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
760-22 with rotary phase converter?	tstom	Bridgeport and Hardinge Mills	1	03-03-2008 12:34 PM
HELP!! How do i get the best size Rotary Phase Converter?	widgitmaster	Phase Converters and VFD	5	11-11-2007 06:22 AM
Running a servo off a phase converter	pstockley	Servo Motors and Drives	0	05-25-2006 09:05 PM
Running a VF-4 on a phase converter??	ZR Machine	Haas Mills	6	11-02-2005 07:04 AM
Rotary Phase converter problems	Gnome	Phase Converters and VFD	5	06-14-2005 09:43 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)