centurian-6; unwanted repeats

[bigbobr]

I have programmed a mill cycle. I have the "start mill" event, then the "circular pocket" event, followed by the "tool retract, end mill" event. The program then repeats this process over and over. I have put this pocket cycle before the drill events and after. To no avail, repeats, repeats. Any and all help would be greatly appreciated. I have checked our manual, but can find no "repeat" call. Thanks

[mactec54]

Hi bigbobr
Post your Gcode here it may be a simple change at the end of the program that will
fix it.

[bigbobr]

Thanks for the response, thing is , I am new to milltronics controls. I have scanned the manual for how to view and edit the Gcodes. Can not find it. I will continue to search and try to post it for you. Thanks again....Bob

[bigbobr]

O.K.; A cup of coffee and several more button mashes and I found the text version of the program. Now I need a run-down of G-codes and P-codes used for these controls....

[mholden]

The pocket clear is a can cycle you do not want the mill start and end.
just remove the start and end mill cycle.
Make sure you have the pocket mill setup