Fixed it. Thank you for all of the help.
Hello all,
I have just experienced a new problem with my centurion 1 control. I turned the machine on and while it was booting an error occurred. It will boot to the screen to select 2 or 3 axis. Once I make that selection, the machine continues to boot up, even going as far as momentarily showing the interface screen. After showing the interface screen for a fraction of a second, a message stating, "Division by zero" shows with several more lines of garb. I took a pic of the screen before shutting the machine down.
Does anyone out there have a suggestion on where to start? Any help would be greatly appreciated.
Thank you
Rob
Similar Threads:
Fixed it. Thank you for all of the help.
What was the solution?
Sent from my iPhone using Tapatalk