vibration problems vm24

[msomerville]

in two different quadrants, no matter how small the cut length of the tool anything, i cant get rid of the chatter. its two opposite corners, and aside from checking the ballscrew and bearings for slop i dont know what else to do .

[single phase]

Did it just start this problem? I assume you refer to two opposite quadrants in the X-Y plane.

Have you checked the level? Could the machine have moved or the concrete have settled? I am not sure how this could cause the problem you have. . .just throwing out ideas.


Dave

[DareBee]

Check that the mounts are secure on the linear rails and on the bearing blocks.