| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Milltronics Discuss Milltronics Machines |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-30-2011, 12:36 PM
| |||
| |||
Anyone else have an issue with there mill not draining the coolant to the tank fast enough? I can't run the coolant at 50% for more than 2 minutes before it fills up to the chip tray and starts to drip on the floor. Its an RH33 without a full enclosure. Theres only 2 small screens way at the back that plug up virtually every job. Has anyone put additional holes in the casting where the coolant flows along to the screens? I believe its hollow underneath?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how are thru hole coolant holes made? | yoshi900 | CNC Tooling | 1 | 03-09-2011 01:31 AM |
| Multiple tapped holes on NC, tapping fluid, or is coolant ok? | Brian FRF | General Metalwork Discussion | 4 | 12-29-2009 05:21 PM |
| Wow the VF3 Drain holes for coolant get clogged up! | Rocko1 | Haas Mills | 4 | 03-11-2008 01:43 PM |
| Coolant or No Coolant when turning.... | Crashmaster | General Metalwork Discussion | 3 | 05-20-2007 01:20 AM |
| holes | Xeno | PTC Pro/Manufacture | 1 | 09-05-2003 06:11 PM |
| | |
Linear Mode
