trying to get bob-cad to talk to milltronics 1D

[blowncoupe]

Can anyone tell me how to get my milltronics 1D to read the posts from
Bob-cad.I can post and save to a floppy but when I put the floppy I the
mill it tells me there is nothing to read error 302 .I know that bob-cad files are .NC not sure what milltronics files are.



thanks

[moldcore]

Our Surfcam generates a .ncc file and works fine. Not sure if .NC is a valid file format with Milltronics. 302 error means the disk is not recognized or not formatted. I’ve seen this error before and replaced the disk with a new one and worked fine. Try another disk or change the file extension to .ncc.

[70cyclone]

you would also need full dos filenames turned on for the control to read a file that isn't in the OXXXX name format

[blowncoupe]

thanks guys for the input. I did find the issue.You can't have a file extension
with this machine. I left the file extension window blank in bobcad and the
machine worked fine.The weird thing is that my laptop with the milltronics
program on it would read it with .NC in the file extension window. It would
even verify it. Thats what through me off.I couldn't figure out why the laptop
would read it but the machine wouldn't

thanks