Partner knee mill question - CNCzone.com-The Largest Machinist Community on the net!

borne2fly · #1 10-06-2010, 03:04 PM

The monitor has a socket on the side for an external keyboard. This socket is about 1/2" dia and has 5 pins with a notch at the top. Doesn't look like a PS2, it's a bit older. Any idea what kind of connector this is and where to get a keyboard that will plug into it?

thedave · #2 10-06-2010, 03:41 PM

It is likely an AT style keyboard connector. This adapter will connect to a standard PS2 keyboard.

Monoprice

borne2fly · #3 10-06-2010, 11:13 PM

Thanks! Glad to know I don't need to run around looking for an antique keyboard.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
feedback on a Z axis kit for a knee mill and mill drill	extsuba	Vertical Mill, Lathe Project Log	1	03-31-2009 06:06 PM
knee mill vs bed mill, brimingham, enco, jet other	allenpnx	Knee Vertical Mills	4	12-18-2007 08:56 PM
Knee Mill vs Square Column Mill	HimyKabibble	Bridgeport and Hardinge Mills	0	11-09-2007 06:27 PM
8x 36 knee mill spindle speed question	krumly	Knee Vertical Mills	0	11-07-2007 03:22 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)