Newbie milltronics partnerIV centurion V - CNCzone.com-The Largest Machinist Community on the net!

bullitt92 · #1 06-30-2010, 08:24 PM

Hello everyone, I need some help finding a centurion V programming manual. I have one for a centurion 1 that came with machine but it is quite different. I would also like to know if anyone knows where I could get a post process file for a milltronics partner IV with centurion V control to run on mastercam x3. Any help would be greatly appreciated, thanks in advance.

jpawelk · #2 07-06-2010, 04:20 PM

Milltronics has Cent 5 manuals available. As far as the post, contact Mastercam. They should be able to help you out as I know they have several posts. Good luck!

bullitt92 · #3 07-06-2010, 04:51 PM

Thank You, I will look into that.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Milltronics Centurion 1 Software & Manual	TZ250	General CNC (Mill and Lathe) Control Software (NC)	1	07-01-2010 11:44 AM
Milltronics 3 axis Centurion 6	Chizel	GibbsCAM	0	05-04-2010 11:25 AM
mastercam x3 to centurion 7 milltronics	motor-vater	Post Processor Files	2	05-30-2009 01:17 AM
Milltronics Centurion 4 amp capacitor	ozturbo	Milltronics	14	10-30-2008 01:06 PM
Milltronics Centurion Six	CUTRITE	Milltronics	10	10-13-2006 01:48 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)