- New here and don't know where to post my question ...
-
Registered
New here and don't know where to post my question ...
Greetings!
I'm new to CNC and have a question about the programs loaded on the OSAI "10 Series" controllers (I don't know if I'm using the right words to explain this box that is essentially a small 486 computer that is attached to a machine).
I've been a computer geek for over two decades so when I was asked if I want to see this "10 Series" that was having a fritz in an industrial production environment, I couldn't resist. Long story short I think it has something to do with networking and maybe even a hardware issue (slowness) after process of elimination to make sure it was not the other components.
I've Googled & found a PDF on "10 Series" from the OSAI in Italy. What I'm looking for is whether there is a utility that diagnoses various components of this controller (10 Series)? Other than the DOS directory I see a lot of other directories with various executables but didn't want to blindly execute them.
Is there a "correct" sub forum catered to these kind of questions and/or OSAI products?
Thank you.
Robert
Similar Threads:
-
- New here and don't know where to post my question ...
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules