- Micromill #19 reporting in
-
Registered
Micromill #19 reporting in
Hello world!
Micromill #19 arrived last week, just had no time to test it out until now
Will report my progress.
During unboxing and first test i noticed that some of the screws that hold the bed aren't flat with it. Unscrewed one at a time and used a countersink bit until flat. While at it mounted them back with threadlock.
The eight unused holes also had a sharp edge, a little work with the countersink bit and it is good.
Similar Threads:
-
- Micromill #19 reporting in
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules