Results 1 to 2 of 2

Thread: Hard Milling CPM-15V

  1. 06-16-2010, 08:36 AM #1
    StuartTool13
    StuartTool13 is offline
    Registered
    Join Date
    Jun 2010
    Location
    USA
    Posts
    4
    Downloads
    0
    Uploads
    0

    Hard Milling CPM-15V

    We are getting a new job in house and have a fair amount of hard milling experience but I am curious if anyone has any thoughts or pitfalls of hard milling powdered metals in the 60 Rc range

  3. 07-04-2010, 03:29 AM #2
    impact
    impact is offline
    Registered
    Join Date
    Mar 2004
    Location
    Delta BC Canada
    Posts
    150
    Downloads
    0
    Uploads
    0
    Clean your coolant tank thoroughly after you are done the job.

« Carbide Inserts sizeing | good "economy" drills/mills? »

Similar Threads

  1. hard milling d2
    By ihavenofish in forum General Metalwork Discussion
    Replies: 8
    Last Post: 09-11-2009, 03:15 PM
  2. hard milling on an nm-070
    By ihavenofish in forum Novakon Systems
    Replies: 4
    Last Post: 08-17-2009, 06:17 PM
  3. Newbie- Hard milling tips
    By Dave ri in forum General Metalwork Discussion
    Replies: 4
    Last Post: 02-17-2009, 10:18 PM
  4. Need Help!- Question about hard milling
    By AMCTony in forum Haas Mills
    Replies: 9
    Last Post: 08-30-2008, 07:26 PM
  5. Milling a very hard material
    By arazelan17 in forum General Metalwork Discussion
    Replies: 0
    Last Post: 02-16-2006, 12:09 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.