| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-15-2009, 11:56 AM
| |||
| |||
when i bead blast larger pieces i cannot get an even coat... any suggestions? Last edited by machinerus; 10-15-2009 at 12:27 PM. Reason: oops  |
|
#2
10-21-2009, 06:28 PM
| |||
| |||
| I'n not sure how big of a part you are talking about, but try doing just two passes, over and back, pretty quickly. Do the whole part this way and check your results, and go back over (the whole part) if needed. I haven't done this with bigger parts, but on smaller parts I have had issue with uneven blasting, the unevenness is magnified by anodizing. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Making PCB with laser (no chemical etch) | RoboticsMD | Laser Engraving & Cutting Machines | 26 | 07-25-2011 07:37 AM |
| CNC/Etch recommendations - high accuracy | MSEE-PHOTONICS | General Metalwork Discussion | 5 | 08-21-2009 09:13 AM |
| Laser Etch Job | clembrant | Employment Opportunity | 0 | 04-08-2008 01:17 PM |
| Can you bead blast plastic? | MagTDK | General Material Machining Solutions | 5 | 08-03-2007 08:02 AM |
| Giant Etch-a-Sketch? | SuperDeLuxe | DIY-CNC Router Table Machines | 14 | 10-12-2006 01:31 PM |
| | |
Linear Mode
