snapontony

[snapontony]

I am looking for someone who has some CNC programing experience,Who lives near Thornton Co.,willing to help me learn CNC on my machines. I am retired and have plenty of time,and very flexable time wise.

[keebler303]

Hi Tony

I'm on the other side of the country and really busy so I'd be of little help but it may be helpful for you to describe what equipment you have, what software, experience, etc. It would allow potential mentors to get an idea of what they are getting into.

Good Luck
Matt

[snapontony]

Hi! Matt thanks for your reply, I have a Sherline CNC lathe and mill which is CNC setup with Acumotion Multi-Axis Motor Driver set up with My Till software. I also have a 2010 Shopmaster Patriot VFD,DRO, CNC mill and lathe como setup with Mach3 software.

[sjh]

Hi dear guy,
I am a CNC Programmer & trainer with about 20 years experience(15 years in teaching of G code Programming).
Unfortunately I am not living in USA. But due to this fact that I am fluent in English language I think I can train u by internet chatting.
We can start the job for a trial term and if u find it useful , u will pay my wage by means of a Bank credit in USA .
Our Programming Courses will be according to Fanuc (and or any other) Controllers and I will send u a Fanuc OM/OT simulator software.
I will my resume in request.
Best Regards
Jalal Haghi
email : infos@sjhaghi.com
s_j_haghi@yahoo.com

[Hennessy]

well if you are still looking for some help I am in aurora co... I don't have a lot of spare time... But I am all ways willing to help out. If you are wanting more of a formal class instruction I can pm you info for the trade school I went to. I know both of the instructors and they have day and night classes. Just let me know

Hennessy

[HelicopterJohn]

Hi Tony,

I just sent you a private message about receiving some help.

John