Hey folks,

Just bought from a friend that recently passed away a Joe's CNC Hybrid 4x4.

I am totally clueless on what do I need to finish this up. I know that the 4 axis Gehko controller is not yet installed, also have a Rover sensor2-phase hybrid stepping motors 1.8 KH42 series.
I am a bit lost because this is a custom built unit and I believe I have all the parts. I will need to install a CNC rotary table with tailstock as well.
This unit my end up being overkill for me since I only need 20"x5" work area. I know have 4 feet
Contact me by pm and I will send my contact information. I am in the central valley on Hwy 5 not too far away from Tracy.