Trying to find JIC/AN fitting dimensions

[aaron p]

Can anyone point me in the right direction to find the dimensions for 37degree JIC/AN hydraulic fittings with the male flare on them. I need to know how wide the flare is, what diameter thread reliefs and such. Sizes #4 all the way to #20. Doing some custom auto racing work and dont know the dimensions for my lathe setup.

thanks,
aaron

[LN-JET]

You need to get in touch with someone in the military logistic system that can supply you with a copy of the original standard. Each P/N will have its own standard drawing listing the different dash numbers. The common union fitting with two male ends is AN815.
If no luck, I can measure some of the surplus fittings i have collected.

Regards
Lars

[brunog]

Aaron,
You can get AN drawings for $25 at: www.usmilitarydrawings.com

Best regards

Bruno

[aaron p]

thanks! Thats exactly what I need. I just gotta sort threw the site. I hope its not $25 each. $150 in drawings I would need. #4,#6,#8,#10,#12, and #16.

[LN-JET]

You should not need to buy one for each size. All the standards I have seen contains all the dash sizes. Just decide on a part number.

Lars

[LN-JET]

Well, spent some time Googling and saved you the cash:-)
You should find what you are looking for in one of theese pages:
http://www.dscc.dla.mil/Programs/Mil...oc=MIL-F-18866
http://www.dscc.dla.mil/Programs/Mil...Doc=MIL-F-5509
Or maybe this is the ultimate: http://assist.daps.dla.mil/docimages...LLLRQMYLYT.PDF

Regards
Lars

[aaron p]

DUDE YOU ARE THE MAN! Id send you a case of beer, but shipping to norway would cost more than the beer! THANK YOU SOO MUCH!

[LN-JET]

No problem, only glad to help.
Cheers, and have a nice weekend!

Lars