In over my head? - CNCzone.com-The Largest Machinist Community on the net!

XHC_Techniker · #1 09-25-2007, 10:20 PM

Would anyone be able to start me on the right track as far as spindle selection. I would like to build a test stand to do spray pattern testing, no cutting. I need a RPM of at least 12,000, it must accept HSK A63 tool holders (can clamp manually or with collet). The spindle selection will drive the rest of the stands design. Any help would be greatly appreciated.

neilw20 · #2 09-29-2007, 02:42 PM

Originally Posted by XHC_Techniker

Would anyone be able to start me on the right track as far as spindle selection. I would like to build a test stand to do spray pattern testing, no cutting. I need a RPM of at least 12,000, it must accept HSK A63 tool holders (can clamp manually or with collet). The spindle selection will drive the rest of the stands design. Any help would be greatly appreciated.

At this speed, I suggest an insight into balance may be prudent.
http://en.wikipedia.org/wiki/Centrifical_force

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Noisy J2 head	Healey	Bridgeport and Hardinge Mills	7	02-05-2007 05:17 PM
In way over my head	protrxrptr17	General Metalwork Discussion	18	11-05-2006 10:02 PM
BP with a M head?	DennisCNC	General Metalwork Discussion	3	02-22-2006 10:41 PM
More HP out of a J head	MrRage	Bridgeport and Hardinge Mills	6	12-04-2005 02:50 PM
M-Head Bridgeport for $650 - E-bay	mxtras	Bridgeport and Hardinge Mills	2	09-13-2005 10:39 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)