Hi

I'm hopping to get some honest opinions on my design, im trying to build my own trunnion table, however im not really a mechanical engineer so im hoping for thoughts.

Im going to sturdy, so for size the main table is a 30mm thick aluminium piece, for the centre piece to hold the bearing im going to make it out of steel the bearings are two 80*50*10mm and driving it is a harmonic drive 1:50.

This is a first draftOpinions sought on my 5axis trunnion table Design-design1-jpgOpinions sought on my 5axis trunnion table Design-design2-jpg

Similar Threads: