Need Help! Mitsubishi Spindle Drive Alarm - CNCzone.com-The Largest Machinist Community on the net!

Antonio Arguijo · #1 01-16-2010, 09:24 AM

I need help about alarm F4 6F in spindle drive display (Drive MDS-A-SP-220) , this alarm appears flashing on the display, I tried to find this alarm in the manual but Isn't appears any information about, someone could help me, please?
MELDAS 500 CONTROL

Al_The_Man · #2 01-16-2010, 10:18 AM

In my manual the 6F alarm is a error in the power supply A/D converter, or other error in the power supply itself.
Al.

onthebumper · #3 01-19-2010, 01:44 PM

Yeah 6F is a power supply alarm. The power supply throws its alarm on the connected spindle drive unit. More then likely your power supply is blown due to old age. Yours should be an MDS-A-CV-#. Mitsubishi doesn't support that drive anymore but they can sell you a newer version that is a direct replacement. You can call them at 847-478-2500.

girishdk · #4 01-27-2010, 12:03 AM

1) Check from Spindle alarm History, any other alarm appeared before 6F.
2) Check CN4 (CV) to CN4 (SP) cable SH21 is connected properly.
3) Check CV Rotary sw. setting.
4) Check value of SP041 = 22

Ref attached for diagnosis

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem- Mitsubishi FR-SGJ Spindle Drive	mikwest	Mazak, Mitsubishi, Mazatrol	8	04-29-2010 04:03 PM
Problem- Mitsubishi DL MAZ Spindle Drive	nnpepe	Mazak, Mitsubishi, Mazatrol	2	03-27-2009 04:30 PM
Need Help!- MITSUBISHI SPINDLE DRIVE UNIT MDS-A-SPJ-75	chagin	General Metalwork Discussion	0	08-09-2008 12:19 AM
Mitsubishi spindle alarm 5022	mroy0404	Mazak, Mitsubishi, Mazatrol	6	04-25-2007 09:11 PM
mazak mitsubishi spindle drive	intermax	Mazak, Mitsubishi, Mazatrol	0	11-03-2006 07:56 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)