Need Help!- Tool Presetter parameters

[cncin]

Today I had one of my operators snap off the button on the tool presetter. We have a Mazak Quick Turn 450II and I was wondering what the parameters were to adjust the tool eye once we get it replaced. I am guessing that when we get the tool eye on and correctly aligned, we will need to readjust positions to be able to use it accuratly again. I remember adjusting parameter for an id tool a long time ago, but can not for the life of me remember the parameter numbers and location. I will obviously need to readjust the od, id, and z locations of the tool eye. If anyone could help me out that would greatly be appreciated and any hints on getting this thing dialed in as quickly as possible. thanks in advance!!!

[bildoo]

I am just pulling this off the top of my head but it think it is parameter B062-B065. I can look it up when I go back to work on Monday. It will be in the parameter manual and there is a diagram as to which parameter is which button.