Need Help! Mazak Camware dongle lpt - CNCzone.com-The Largest Machinist Community on the net!

speedchaser · #1 08-05-2009, 02:41 PM

Hello All long time reader
looking for some help on a camware dongle LPT type
trying to get it to work with new computer that dose not have a lpt port off the mother board.
and it will not see a lpt port that is on a pci card
running vista 64 I think the dongle is looking for Irq 7 but vita will not let me change the Irq settings in the device manger.
the pci card that I'm trying to run is a Moschip pci Parallel port

Thanks For your Time
Speed

jimiscnc · #2 08-10-2009, 08:12 AM

I would suggest calling the main number for Mazak Kentucky and ask for a Camware guru! You may need to turn in your serial dongle for a usb dongle?

-90% jimmy

MrMazak · #3 08-10-2009, 08:27 AM

USB to LPT adaptor should work.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- camware	stilleogrolig	General CAM Discussion	0	11-17-2008 03:04 PM
camware	binaryman	General CNC (Mill and Lathe) Control Software (NC)	0	10-04-2007 03:20 PM
Mazak Camware	CNCtoday	Mazak, Mitsubishi, Mazatrol	1	09-28-2006 07:28 AM
Mazak Camware Expert	joedirt	Mazak, Mitsubishi, Mazatrol	3	09-12-2006 12:17 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)