M-2 Comm Board Help - CNCzone.com-The Largest Machinist Community on the net!

newguy81 · #1 06-03-2009, 02:11 PM

Can anyone tell me which board is used for communicating via mazatrol not G-code/EIA. M-2 Control. My comms just quit working. I have a full set of boards from another machine and multiple machines to pull from if I can find out which board. Mazak still doesn't return calls on used machines from the Houston office. Thanks in advance.

chippy1 · #2 06-04-2009, 08:31 AM

Should be the FX27 PCB, but you will loose parameters by swapping it. Make sure you have a hard copy.

Regards,

Chippy

newguy81 · #3 06-04-2009, 10:14 AM

Chippy,

I don't see FX-27. I do see FX-727

chippy1 · #4 06-04-2009, 10:18 AM

Yes, the FX727 is a higher levelk card and that card is also where the Mazatrol comm is located. You must have a YM2V oor YM2B/C

Regards,

Chippy

newguy81 · #5 06-06-2009, 12:09 PM

Fixed it. Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Comm software rec	bigalow	Machine Problems, Solutions , Wireless DNC, serial port	3	04-18-2008 06:25 PM
Need Help!- RS-232 comm problems	Crashmaster	Fanuc	2	04-03-2008 01:56 PM
VB 6 Comm PIC Processor	frog	Visual Basic	0	02-12-2008 07:16 PM
comm 1 is out help please	dcrblazer	Milltronics	0	04-16-2007 10:26 AM
Comm Cable	EvilScooby	General Electronics Discussion	3	07-03-2003 06:16 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)