Need Help! T MSR AUTO MODE IN MAZAK! - CNCzone.com-The Largest Machinist Community on the net!

sridhartsr · #1 03-27-2009, 12:13 PM

Hi Gents,
In v655/80 MAZAK (M32B) machines tool length measuring unit I wants to change the position, my problem is T MSR auto mode working in particular position only, we can change that? Any option is there pls assist. Thanks.

psychomill · #2 03-27-2009, 11:26 PM

Yes, you can change the position. It's an R parameter but I can't remember which one right off the top of my head. Maybe someone with the list can chime in...

bildoo · #3 03-28-2009, 04:34 PM

The tool setter position and height are set in the R parameters i belive around R2392. Look in the electrical diagram book there will be a list of them in there. I know there is also a R parameter that allow the mesurement of endmills. Sorry i dont have a book at home or i would tell u that the actual parameter numbers are.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem- Drip feed mode for Mazak M32	CimUser2000	Mazak, Mitsubishi, Mazatrol	5	07-11-2010 07:55 PM
Need Help!- Mazak QT15 with T32-B control does not switch to automatic mode	MarkusFunk	Mazak, Mitsubishi, Mazatrol	2	06-05-2008 09:54 PM
Mazak Integrex 100Y Subspindle Milling Mode not working	mzbik	G-Code Programing	3	01-22-2007 12:59 PM
Using G12.1 Milling Mode on a Mazak Integrex	mattclubb	Mazak, Mitsubishi, Mazatrol	8	12-22-2006 11:24 PM
Single line mode works well, Auto is not soo good??	Darc	CamSoft Products	16	10-26-2004 03:29 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)