alarm 283 - CNCzone.com-The Largest Machinist Community on the net!

nestor82 · #1 02-26-2009, 09:21 AM

We have a Mazak v10 with a M2 control on it, last night one of my "wonderful" operators hit reset in the middle of the tool change, I have just about everything back into place, but we have a 60 tool carolsel, and the second arm that puts it into the caroulsel didn't return to position as thats where the tool was when it got screwed up...... Can anyone help with how to get that upper arm to return back to its default position? Tried messing with the selinoids in the back as well, but to no avail?

Thanks,

Nestor

jimiscnc · #2 02-26-2009, 11:48 AM

just wondering. stuff like this happens so much the service support people can probably recite instructions over the phone from memory.

-jim

nestor82 · #3 02-26-2009, 05:50 PM

yeah, about five seconds into it, though about the time they called me I was in the right menu and just about had it, but very helpful!!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NEED HEELP ALARM #414 Y AXIS SERVO ALARM?	PICMAN	Fanuc	6	04-29-2011 05:20 PM
ALARM shuttle drawbar alarm haas	timmydabull	Haas Mills	27	10-30-2009 08:27 PM
Problem- Alarm 350, not in my alarm list, any ideas?	ralph@nes	Mazak, Mitsubishi, Mazatrol	4	09-27-2008 01:14 PM
alarm 408 servo alarm "serial not RDY", αP18 fanuc mtor code	sting	Fanuc	0	01-01-2008 09:03 AM
VFE - ALARM# 117	j-radkemachine	Haas Mills	2	12-06-2007 04:57 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)