Need Help! Work offset page for Mazak VTC-41 - CNCzone.com-The Largest Machinist Community on the net!

02-04-2009, 08:24 AM

Jcip

Join Date: Nov 2006

Location: The Great USA

Posts: 28

Work offset page for Mazak VTC-41

permalink

I bought a used 1993 Mazak VTC-41 with a Mazatrol EIA control (Yasnac MX3) I can not find the work offset page anywhere I used Yasnac controls on Matsurras in the past and they were on the offset page, but not on the Mazak, In the manual it says to go to the offset page and select the "next" button until it comes up but the only othet page is Tool life management page. I can see the workoffsets in the parameters screen but no work offset page.

Any help would be appreciated

Jim C

Last edited by Jcip; 02-05-2009 at 11:37 AM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mitsubishi Meldas - Switching Tool Offset Page Type	avongil	Mazak, Mitsubishi, Mazatrol	2	09-18-2008 02:20 PM
Work Offset Question	Cartierusm	Mach Software (ArtSoft software)	17	11-29-2007 03:50 PM
Display Absolute on tool offset page	billm	Fanuc	0	02-14-2007 02:12 PM
work offset in fanuc 6m b- help	rags	Fanuc	14	08-03-2006 09:39 PM
NC reading tool length from offset page, not data page..?	RMagnusson	Mazak, Mitsubishi, Mazatrol	1	03-21-2006 04:07 PM

All times are GMT -5. The time now is 12:31 AM.