Mazatrol Sub Program

[jhersh]

When using an EIA sub program within a Mazatrol program is there any way to give it a priority? Without a priority it defaults to putting the sub program at the end, but I need it to be at the beginning of the main program. The other units in the Mazatrol program all have priorities, therefore forcing the EIA subprogram to the end.

[MrMazak]

Put a PROCESS END unit right after the sub call. That will separate the program into two sections and should run like you want it to. You could also change the entire priority to DELAY and it would run the way you want it to.

UNO-1 WPC

UNO-2 SUB 1000

UNO-3 PROCESS END

UNO-4 etc, rest of program uses the piority system.

[jhersh]

Thanks MrMazak, that did the trick!