CNCzone Network: RFQwork :: 3Dstuffzone :: Welderzone
options and dnc m32b
contol is m32b
If I push "MNT" button, then "version" , I get a page that has a list of options, listed below:
1: EIA (I take it that means "g code")
2: dnc (so I should be able to up/downlaod thru rs232)
3: spiral (helical interpolation?)
4: EIA 3-D comp (no idea what this is)
6: geometric (no idea what this is)
8: EXT-data I/O (no idea what this is)
10: MEM 76m
11: FLX print
When I try to send out a program with dnc, I get a "570 no dnc option" alarm, the alarm manual says that I need to have dnc installed. But isnt that what #2 on the list above is telling me I already have?
So, is this list on my control what my control actually has?
If so, why do I get the dnc alarm?
What do options 4, 6, and 8 do?
By sunfire03 in forum Mazak, Mitsubishi, Mazatrol
Last Post: 04-09-2008, 06:04 PM
By spock in forum Mazak, Mitsubishi, Mazatrol
Last Post: 03-15-2008, 11:30 AM
By chippah in forum Mazak, Mitsubishi, Mazatrol
Last Post: 02-01-2008, 04:57 PM
By k8bebop in forum Mazak, Mitsubishi, Mazatrol
Last Post: 01-29-2008, 08:04 PM
By iwebcodms in forum LinuxCNC (formerly EMC2)
Last Post: 11-15-2007, 10:09 PM