M-2 Memory - CNCzone.com-The Largest Machinist Community on the net!

newguy81 · #1 08-07-2007, 12:51 PM

Anyone know of an after market memory upgrade for the Mazatrol M-2. Need to do some 3D work and don't have near enough memory. Or does anyone know how to drip feed an M-2. Thanks, Joe

GEM · #2 08-30-2007, 04:24 PM

Be careful, it might not just be a memory upgrade, you might also require the 3D option Roms

Fish · #3 09-05-2007, 01:13 AM

Hey Newguy81,

Forget about an upgrade on an old M2, the cost is more than the machine is worth. I have an old AJV25/404 that I regularly drip feed long programs into. It works fine once you have it set up. I use an older free copy of NC Link from One CNC. I know they don't give it out anymore, but I can email you a copy. It was free remember, so no copywright problems. There are a few things to do so that it works. Send me an email at gofastdesigner@hotmail.com and I can help you with it. It's not difficult, and it works well.

Fish

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
need more memory	rob2424	Machine Problems, Solutions , Wireless DNC, serial port	1	01-28-2008 05:04 AM
Out of Memory errors	trevj1	Milltronics	18	08-09-2007 08:00 PM
88 Memory ?	Bear	Fadal	2	09-01-2006 06:26 AM
EMC memory error	tomekbrzozowski	LinuxCNC (formerly EMC2)	1	07-03-2006 03:04 PM
Bubble memory	Darkos	Fanuc	3	06-06-2006 03:29 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)