M2 hidden parameters - CNCzone.com-The Largest Machinist Community on the net!

swhitejhr · #1 07-23-2007, 02:43 PM

How do I view the OP machine parameters. I am trying to replace the fx727 board in a mazak M2 and the procedure for entering the new parameters says to go to the OP parameters. These do not show up. I somewhat remember a secret handshake to make them show up but it's been a while. Please help.

andyt · #2 08-03-2007, 11:16 AM

When you're in the parameter screen, page to the last of them before it rolls back. Hold F3 key in while simultaneously pressing the page key. Do this once and the hidden parameters are shown.

GEM · #3 08-03-2007, 12:09 PM

Is it not F2 & F3, whilst holding pressed, page over with next page/previous page key

andyt · #4 08-03-2007, 12:22 PM

No. Just F3 and the page key.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
parameters for G71	harrascustom	G-Code Programing	0	04-09-2007 10:06 AM
hidden lines only for some features in solid works	viny	Solidworks	5	02-14-2007 12:48 AM
18i hidden parameter view/change?	john k	Fanuc	6	12-22-2006 12:58 AM
Bridgeports hidden buttons on cncs	leggetmachine	Bridgeport and Hardinge Mills	5	08-19-2005 12:22 AM
Hidden Backlash!	CharlieM	Mach Software (ArtSoft software)	2	05-07-2005 11:07 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)