Anyone know how to turn the parts counter on?

[mattme]

We have a Mazatrol T1 that is running a program in a SGL mode. The machine recently just had all the memory wiped out and redone. When I put the old program back in as we had it written down, the part counter don't work. Anyone know how I can turn this back on?

[laamar]

I'm no expert but if you add as the last line END and where it says parts put a 1 there this should work, on this line you can swtsh on the repeat as well. Hope this helps.

[mattme]

unfortunately there's nothing that asks me if I want to turn the counter on in the mode the program is in. It's currently in SGL mode.

[SteelCutter]

Try going to your command page and setting it in there, this works on T2 controllers.

I wish you success

[mattme]

Got the parts counter to turn on. It seems the program will run without an END mode in the program. And it wasn't exactly clear how to put that in, but I came upon it by getting curious and pushing buttons to see what they did. When I got the END mode put in, it asked if I wanted it turned on.