cutter comp in eia - CNCzone.com-The Largest Machinist Community on the net!

mrwright · #1 05-21-2007, 05:19 AM

Can anyone help me with cutter comp in an eia program on the Integrex 200?
I can get it to work with turning tools but not with milling tools. All of the examples in the eia manual are for turning.

Frankbals · #2 05-21-2007, 06:15 AM

you need to use G128 or G125 depending on the control, then use wear comp in Mastercam if you are using Mastercam.

mrwright · #3 05-21-2007, 07:34 AM

Frankbals,

what exactly is G128 or G125? I cannot find either one in my programming manuals that came with the machine.

Frankbals · #4 05-21-2007, 07:53 AM

G125 (8) Changes the plane on the integrex, it's a great feature, I'm sure you have it. Without it if you were say end milling a face at B45, your moves would all be xyz, with G125 your machine would make this a plane and use only x, y, moves so cutter comp will work. I'm looking for some documentation for this.

Good luck,
Frank

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3-axis cutter comp?	ghyman	G-Code Programing	15	06-28-2009 11:54 PM
Cutter Comp.	Big"E"	General Metalwork Discussion	8	03-28-2007 11:05 AM
BobCad Cutter Comp Help	carveceltic	BobCad-Cam	2	01-14-2007 10:10 PM
18-it cutter comp	newcinhypro	Fanuc	1	01-25-2006 08:00 PM
Not using cutter comp	HuFlungDung	OneCNC	6	05-28-2003 04:59 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)