Parts counter - CNCzone.com-The Largest Machinist Community on the net!

daewooevc · #1 10-26-2006, 08:01 AM

I can't seem to locate a parts counter on my Mits. M520 on a Daewoo DMV 500. Can anyone help? Thank You

MetLHead · #2 10-26-2006, 04:36 PM

There should be a parts counter on the coordinate screen. Press Monitor then press the COORD softkey. Counter should be in the upper right corner. I believe that there's a parameter that sets what M-Code will increment the counter.

Regards,
Scott

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)