Mazatrol T Plus is there a conversation mode? - CNCzone.com-The Largest Machinist Community on the net!

Castle1 · #1 04-15-2006, 01:03 PM

We have a Mazak Lathe with a Mazatrol T plus control, is there a way to tell if there is a "conversational" mode, and if so how do I enter into it?
Thanks
Castle1

Castle1 · #2 04-18-2006, 09:59 PM

I guess that was kind of a dumb question. "Mazatrol" is the conversational language. All Mazaks have it, it's the EIA G-code thats optional.
I got into it, we are going to get the Mazatrol programming book. Only room for 16 work no's, maybe a memory upgrade too.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)