| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mazak, Mitsubishi, Mazatrol Discuss Mazak, Mitsubishi and Mazatrol systems here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-09-2006, 10:50 AM
| |||
| |||
Im using cimco software to link my t32 to a pc to store all my programs,my problem is i cant reload the programs back into the t32. I can save the programs, and veiw the programs on the pc via the controller, but when i go to load the program i keep getting the cmt misconnected error(error 515), the mazak alarm list is telling me that my cable is misconnected or a paramerter is set incorrectly. i dont have a clue how to set the parameters and if the cable was misconnected i would not be able to view or save the programs . I need help, getting very frustrating.    |
|
#2
02-09-2006, 04:19 PM
| ||||
| ||||
| If you have a fully populated cable right now, try using a 3 conductor with handshake jumpered, see the www.cadem.com site for cable & Parameters http://www.cadem.com/ncnet/dnc-detai...zak-t32-m2.pdf Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
