Hi everybody,

I am a new user with an old problem.
In fact I try to save / load programs from Mazatrol M32, but till now don't works.

I have try several combination of settings on board and on pc programs, but noting.
I use the Cimco V5 or Cadem to trasfer data.
The DNC function don't seems to work, so I have test with CMT and Tape, but I receive the 515 Error message.

I think my problem is in the CNC settings, so I found this forum.

I the earlier post (Stupid newbie - M32 Tape connection - CNCzone.com-The Largest Machinist Community on the net!), I have seen some settings for
" User Parameter No 4 I1 = 2....", but In my on board setting page for User Parameter No 4 I have the axes settings, like I1 = 0 axis x, I2 = 0 axis y, I3 = 0 axis z, ecc.

My question is where I can set the CMT or Tape settins?

Thanks for help!