| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mazak, Mitsubishi, Mazatrol Discuss Mazak, Mitsubishi and Mazatrol systems here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-20-2011, 06:02 AM
| |||
| |||
Dear All, On my new VQC20/50, the original DB25 female DNC plug has been replaced by a RJ45 one. Since there is no official standard for cabling EIA-232 on RJ45. Does someone know the original cabling for finding for the correct PC wire map? This are some picture of the plug (front view/ rear view and sticker showing wich card are used)    Also what is the switch -wires SDC1 or SOC1- on the top right of the door?  |
|
#2
10-20-2011, 07:01 AM
| |||
| |||
| Am I mistaken, or is the original wiring for the DB25 plug still in place?
__________________ http://www.kirkcon.com/ |
|
#3
10-20-2011, 07:13 AM
| |||
| |||
Tomorrow I'll disassemble Last edited by eltorio; 10-20-2011 at 07:39 AM. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mazak QT 15 with Mazatrol CAM T-2 | cncren | General CNC (Mill and Lathe) Control Software (NC) | 1 | 02-23-2012 06:06 AM |
| Mazak M-4 Mazatrol T2 and mazatrol Cam T2 operating manual in english | tuanpq | Mazak, Mitsubishi, Mazatrol | 21 | 01-21-2012 07:33 PM |
| Mazak VQC20/40B Mazatrol Cam M-2. Alarm 22 and 23 batterie low, parameters wrong. | sve0019 | Mazak, Mitsubishi, Mazatrol | 0 | 04-05-2011 02:12 AM |
| Mazatrol T1 - Mazak | valvulin | Spanish CNCzone | 0 | 10-31-2008 04:17 PM |
| Mazak, Mazatrol T1 | valvulin | Spanish CNCzone | 1 | 10-10-2008 12:17 PM |
| | |
Linear Mode
