Mitsubishi MH-4A CNC Horizontal Machining Center

[HobbieZones.com]

Hi,

Well after many months of web reading and many tecks was able to get Mill to Upload and Download programs.

It would download to pc all day long .

Now the Upload to the Mill was another deal we got codes and codes but with the help of this VERY Forum found a post that did help a LOT.

List of codes we got are

E07 Reset End

E08 Physical Err

E09 Time Out

E17 Parity H Err

E20 Over Run Err

E65 Program No Dupl

E66 No Program Number


Video of Progress YAHOO !!

http://www.youtube.com/watch?v=t5cPwESIGMA

http://www.youtube.com/watch?v=t5cPwESIGMA

So just want to give back and hope someone else has as much luck as we did.

Some of the Pram have changed this is the settings that got it to go but have made a few changes and upload speed is much faster. Will edit and add more pic's so hope this helps someone someday.

















Change this to 1000 anything less and was just unable to get it to work.



So far dont matter what set at.

[HobbieZones.com]

http://www.cnczone.com/forums/genera...e08_error.html

[HobbieZones.com]

http://www.cnczone.com/forums/contro..._problems.html

[HobbieZones.com]

Well Just want to pass along some Settings that are working very nice. Hope they help someone someday.

























This is the only cable setup that would work had to have it just like this. It would send from Mill to PC just fine but to upload a program had to add the other wires.