Ok, the "regeneration" procedure worked great. We are now able to turn the spindle on, tool change etc, in MDI.
However, every time we do a toolchange we get a "25 ATC Error". Also we can not rotate the tool carousel through MDI. I believe this has to do with the tool registration page being blank. (I don't have any real experience with this style toolchanger, only the "umbrella" style). I tried going thru the manual and did find a spot that gives instructions on inputting values here, but all I get is an "E01 setting error" when I try to input anything. Could you walk me through what I'm doing wrong?
Also, RS232 comms aren't working. Again I went thru the manual and checked and changed a few parameters but no luck. There is one parameter that handles the handshaking type. There appears to be only 3 choices - RTS/CTS, no handshaking, or DCS type. I have a 3 wire cable setup for Xon/Xoff handshaking, it makes me wonder if I'll need a cable setup for hardware handshaking. Any input here?
Thanks so much for getting us to this point!
Also, the control is a 330HM. Not sure what the difference between the M and HM are, but wanted to update that.