FCE GRV width of cut (Integrex35)

[PatCartier]

Hi,

I'd like to know wich parameter sets the percentage of the tool width to use as cutting width when face grooving (turning, not milling) on a Mazak integrex 35 (Mazatrol T plus). As it is right now, it isnt enough and a lot of production time goes to waste because of all the extra passes the machine does. I know I could trick the machine into making less passes by changing the tool width in Tool Data and programming 2 FCE GRV processes (one n2, one n3) compensating in the program itself... but I share the machine with others and having an inexact Tool Data is not a risk I want to take.

I would appreciate it a lot if someone could tell me how to set it right.

[60rock]

Parameter change, should be viewed in the specific unit TPC or in parameters page