Problem Tool offset in old Meldas 310 - CNCzone.com-The Largest Machinist Community on the net!

07-20-2011, 01:55 PM

Ola Fischer Ola Fischer is offline

Join Date: Jan 2011

Location: Sweden

Age: 37

Posts: 1

Tool offset in old Meldas 310

permalink

I'm using an old Leadwell MCV-OP with Meldas 310 from -89. Is there anyway to display the programmed Z value when G43/44 (toollengthoffset) is active? It's a thrill everytime untill you see the first cut...

/Ola

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to change tool offset memory type on meldas 500?	Francois_DCM	Mazak, Mitsubishi, Mazatrol	6	03-31-2010 08:12 AM
Renishaw tool offset / break probe and tool life management	mcash3000	General CNC (Mill and Lathe) Control Software (NC)	0	02-20-2010 09:14 PM
meldas-m0 Cannot input G54 offset numbers	Place2809	Mazak, Mitsubishi, Mazatrol	5	09-22-2009 04:29 PM
Changing tool diameter in the tool offset screen	Vern Smith	Haas Mills	21	09-24-2008 09:54 AM
Mitsubishi Meldas - Switching Tool Offset Page Type	avongil	Mazak, Mitsubishi, Mazatrol	2	09-18-2008 02:20 PM

All times are GMT -5. The time now is 02:50 AM.