PC <-> Brother TC-S2A - cable ok, no connection

[Ben Colby]

Hello,
Well you are further along than I am. I can download without error but it won't upload
from the pc to the Brother. I had RYM's tech helping me for a while but we never solved it. Yamazen doesn't support my older machine anymore so I'm still stuck.
Another CNCzone member got his machine to work with a free terminal program,
but it doesn't work on mine. It's extremely frustrating! I hate deleting perfectly fine
programs.
Where did you purchase the TCeditor? I'm willing to give anything a try, I don't
even care about the cost anymore. It's just ridiculous that such an easy thing
is so difficult with their controls.

[mahi]

I got the software when I bought the machine (from MTG Belgium), but the software is neither from Brother, nor from MTG, so I assume it should be available elsewhere too. I'm not at work right now, but I'll look up what company wrote the software next week. If I recall correctly, they did have a demo version (time limited dongle), so if you could get your hands on that you could test it before spending a lot on it. I forgot what the software costed, but it was WAY too much...

TCEditor is not just a communication program, though. It's a complete programming suite for the Brother.