02-09-2011, 09:02 PM
|
| | | Join Date: Apr 2008 Location: usa
Posts: 33
| |
Updating the command page on my m32 | |
We have two old AJVs a 1989 and a 1990. We have used them for 20 plus years running Mazatrol. I would like to run gcode on them. We Had a Mazak tech come in to help us set these two machines up to run gcode. We do have the EIA option on them. We were able to get them to run however I can't seem to get the Z to read the tool length on the command page. It will run the program correct and the tool length is correct it just will not update the Z on the command page. The F-84 Par bit 1 is set to 1 however it doesn't respond. I also have it set for type B offsetting. The tech told me we need a CO or newer version of software to correct the problem. . I think I am just missing something. We have two more M32 H-800 s' one is a 1990 and the other is a 1994. They work fine. I have a hard time believing I must spend $2500 or more on software for these two machines. Has anyone been down this road? |
Similar Threads 
Linear Mode
